PETOL™ Hydraulic Friction Breakout Unit
PETOL™ Hydraulic Friction Breakout Unit Pump Shop PETOL and TITAN Tools Johor Bahru (JB), Malaysia, Johor Jaya Supplier, Suppliers, Supply, Supplies | Leo Automation Trading
The PETOL™ HYDRAULIC FRICTION BREAKOUT UNIT will not mar the surface of the parts being made up and broken out. Each Hydraulic Friction Tong and PETOL SURGRIP™ Vise Bushing is bored to grip a specific O.D. by friction alone. Vise bushings are held in place by a spring loaded plunger for quick change out. The units are powered by an electric motor and have a pressure gauge that reads out in ft.-lbs. of torque. For added safety, a controlled pressure relief valve allows the operator to adjust the working pressure for each job. When the set pressure is accomplished the system stops torquing.

NOTE: Maximum working loads range from 500 ft.-lbs. to 5,000 ft.-lbs. depending on size of tong being used.

Hydraulic friction breakout units.

The PETOL SURGRIP FRICTION VISE and hydraulic cylinder will slide the entire length of the PETOL Hydraulic Pump Bench to grip different areas on the workpiece and change from the makeup to breakout position.
Hydraulic friction breakout units.

The PETOL HYDRAULIC FRICTION TONGS have perfect ratcheting action. A quick release pin enables the operator to quickly change out sizes.
Hydraulic friction breakout units.

PETOL PLATERENCHES are used with the PETOL HYDRAULIC SOCKETRENCH HANDLE to makeup and breakout parts with wrench flats.
Hydraulic friction breakout units.

The PETOL BENCH SADDLE offers additional support for the work piece. The height of the bench saddle is adjustable, and it can be moved the entire length of the bench.
PETOL™ Hydraulic Friction Breakout Unit
ZB1260U* PETOL Hydraulic Pump Bench - 32' High 300 lbs.
UHCN-ZB-E** Hydraulic Console for Pump Bench 33 lbs.
ZI1260-7 PETOL Bench Installation Kit 1 lb.
  *Includes cylinder assembly
**Includes electric motor and hose assemblies

Do Not Exceed Maximum Working Load.
Overloading may result in injury or death.
Always use a load cell or other calibrated indicating device to monitor the line pull on the tong to avoid overload.
Do not operate without a manual.
Follow OSHA, NSC, etc. standards, safe practices, & procedures.

Please leave your enquiry here, we will reply as soon as possible.

*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version